0

Janome Lower Looper Assembly

£34.50

GTIN: Loc C 047 Category:

Here is a Janome lower looper assembly. Overlocker loopers can become damaged over time. Worse case scenarios, they can even snap in two. The gap between upper and lower loopers is only small. So if anything ‘slips’ they will strike each other and break.

Be aware that when you fit a new looper the timing may also have slipped. So you must take great care when you test your overlocker. Do Not use the foot control. After fitting the new looper turn the hand wheel slowly. Make sure the two loopers don’t strike each other. Also make sure the loopers don’t hit your needles – new needles, please.

 

This Janome Lower Looper Assembly will fit the following overlocker models,

614
634
704

© 2024 Bamber Sewing Machines
Powered by woo-creative.co.uk